Automatically Re-Numbering All Document Entities

Last modified on December 1st, 2014.


This section contains outlined instructions for how to automatically re-number every entity of your requirements document.

  1. Within ‘Requirements View’, ensure the requirements document you would like to automatically number is displayed. The document used in this example, as shown below, was created to demonstrate that no matter how poorly numbered your document is, the "Auto Number" function can re-number every document entity automatically based on hierarchical decomposition.

    Poorly Numbered Requirements Document

  2. Click on the ‘Auto Number’ button as shown below:

    Click Auto Number Button

  3. The ‘Auto Number Document’ panel will appear, where you can enter a prefix if you so choose. Optionally type in a ‘Prefix’ and click the ‘Run’ button.

    Auto Number Document Panel

    Note: Depending on the size of the document, the "Auto Number" function may take a few seconds to run.

  4. Once the "Auto Number" function has finished running, 'Requirements View' will refresh to display your newly re-numbered document, as shown below:

    Newly Re-numbered Requirements Document

Automatically Re-Numbering All Document Entities

Last modified on December 1st, 2014. 


This section contains outlined instructions for how to automatically re-number every entity of your requirements document.

  1. Within ‘Requirements View’, ensure the requirements document you would like to automatically number is displayed. The document used in this example, as shown below, was created to demonstrate that no matter how poorly numbered your document is, the “Auto Number” function can re-number every document entity automatically based on hierarchical decomposition.

    Poorly Numbered Requirements Document

  2. Click on the ‘Auto Number’ button as shown below:

    Click Auto Number Button

  3. The ‘Auto Number Document’ panel will appear, where you can enter a prefix if you so choose. Optionally type in a ‘Prefix’ and click the ‘Run’ button.

    Auto Number Document Panel

    Note: Depending on the size of the document, the “Auto Number” function may take a few seconds to run.

  4. Once the “Auto Number” function has finished running, ‘Requirements View’ will refresh to display your newly re-numbered document, as shown below:

    Newly Re-numbered Requirements Document